Bently Nevada 60M100-00 Magnetic electric speed sensor

Bently Nevada 60M100-00 Magnetic electric speed sensor

Specific Parameters​

Electrical Parameters​

Working Principle Magnetoelectric induction type, no external power supply required (passive sensor)​

Output Signal Type Sinusoidal AC signal, signal amplitude varies with speed​

Speed Measurement Range 20rpm to 20,000rpm, suitable for monitoring medium and high-speed rotating equipment​

Output Signal Amplitude ≥200mVpp at 1000rpm, ≥1Vpp at 5000rpm, maximum output amplitude ≤25Vpp​

Frequency Response Range 1Hz to 333Hz (corresponding to 60rpm to 20,000rpm)​

Load Impedance Recommended load impedance 1kΩ to 10kΩ, maximum allowable load impedance 50kΩ​

Insulation Resistance Insulation resistance between sensor coil and housing ≥100MΩ (500VDC)​

Withstand Voltage Withstand voltage between sensor coil and housing ≥1000VDC (duration 1 minute)​

Temperature Coefficient Output signal temperature coefficient ≤±0.1%/℃ (-40℃ to 120℃)​

Mechanical Parameters​

Overall Dimensions Diameter 18mm, length 100mm (standard straight rod structure), lead length 3 meters (customizable 5m/10m)​

Weight Approximately 200g (including leads), lightweight design facilitating installation and deployment​

Mounting Method Threaded mounting (M18×1.5 thread), mounting gap 0.5mm to 2.0mm (recommended 1.0mm)​

Probe Material Housing made of 316 stainless steel, wear-resistant and corrosion-resistant; sensing end adopts neodymium-iron-boron permanent magnet​

Connection Method Two-core shielded cable leads, conductor material is tinned copper wire, shield layer is braided copper mesh​

Protection Rating IP67, fully sealed structure, dustproof, waterproof and oil-resistant​

Mounting Torque Maximum mounting torque 25N·m to avoid thread damage​

Environmental Parameters​

Operating Temperature -40℃ to 120℃, no performance derating over the entire temperature range​

Storage Temperature -55℃ to 150℃, meeting extreme storage and transportation requirements​

Relative Humidity 0% to 100% (condensation allowed), adapting to high-humidity and foggy industrial scenarios​

Vibration Resistance Complies with IEC 60068-2-6 standard, 10g acceleration at 10Hz-2000Hz frequency range​

Shock Resistance Complies with IEC 60068-2-27 standard, 50g acceleration (duration 11ms)​

Corrosion Resistance Resistant to corrosion by petroleum, diesel, hydraulic oil, industrial chemicals and other media (complying with NEMA 4X standard)​

Product Performance​

Stable signal output, passive design without power supply, output ≥200mVpp at 1000rpm ensuring reliability of signal recognition​

Wide range coverage, 20rpm to 20,000rpm range adapting to various rotating equipment from small and medium-sized motors to industrial turbines​

Strong environmental adaptability, -40℃ to 120℃ wide temperature operation + IP67 protection + corrosion-resistant design tolerating harsh industrial conditions​

Convenient and flexible installation, M18×1.5 standard thread + 1.0mm recommended mounting gap adapting to most equipment mounting holes​

Rugged and durable structure, 316 stainless steel housing + high-strength permanent magnet, vibration-resistant and shock-resistant, service life ≥10 years​

Wide compatibility, compatible with Bently Nevada full-series monitoring systems and third-party industrial controllers, PLCs​

Strong signal anti-interference, shielded cable leads + electromagnetic induction principle reducing the impact of industrial electromagnetic environment interference​

Low maintenance cost, passive design without electronic components, extremely low failure rate, no regular calibration required​